T o specify a tunnel interface, you use the tunnel ID. T o specify a loopback interface, you use the loopback ID. Using the Command-Line Interface 12 ProSafe M4100 and M7100 Managed Switches Note: In the CLI, loopback and tunnel interfaces do not use the slot/port format. The software also uses this convention to identify certain logical entities, such as Port-Channel interfaces. Using the Command-Line Interface 11 ProSafe M4100 and M7100 Managed Switches Slot/P ort Naming Convention Managed switch software references physical entities such as cards and ports by using a slot/port naming convention. T able 1 describes the conventions this document uses to distinguish between value types. Using the Command-Line Interface 10 ProSafe M4100 and M7100 Managed Switches The parameters for a command might include mandatory values, optional values, or keyword choices. Some commands, such as show network or clear vlan, do not require parameters. Parameters can be required or optional values. Using the Command-Line Interface 9 ProSafe M4100 and M7100 Managed Switches Command Syntax A command is one or more words that might be followed by one or more parameters. Using the Command-Line Interface 8 ProSafe M4100 and M7100 Managed Switches Licensing and Command Support As shown in the following table, some command groups, or commands, require a license and some are supported on particular switch models. Y ou can access the CLI by using a direct serial connection or by using a remote logical connection with telnet or SSH. U sing t he C omman d-L ine Int erf ace The command-line interface (CLI) is a text-based way to manage and monitor the system. 610 Link Local Protocol Filtering Commands. Ħ ProSafe M4100 and M7100 Managed Switches Software License Commands. ĥ ProSafe M4100 and M7100 Managed Switches Chapter 6 IPv6 Commands Tunnel Interface Commands. Ĥ ProSafe M4100 and M7100 Managed Switches IGMP Snooping Configuration Commands. Y ou must register your product before you can use NETGEAR telephone support.ģ Content s Chapter 1 Using the Command-Line Interface Licensing and Command Support.

After installing your device, locate the serial number on the label of your product and use it to register your product at. 350 East Plumeria Drive San Jose, CA 95134 USA February 2013 202-1 1 166-02 1.0 Pr oSaf e Manag ed S w it ch Co mmand L ine Inte rfa ce (CLI) U ser Man ual 10.Ģ ProSafe M4100 and M7100 Managed Switches Support Thank you for selecting NETGEAR products.

Change netgear mac filtering